Skip to content
MomentumMomentum
Esc
↑↓navigate↵open⌘Jpreview
On this page

CLI

The momentum commands and how the CLI finds the headset.

momentum status
momentum status --json
momentum set transparency 40
momentum set eq-preset harman
momentum set eq -3.5 -0.5 2.5 -0.5 -0.5
momentum set sound-mode speech
momentum set codec aac
momentum set call-profile-switch off
momentum --help

The CLI finds the first connected Bluetooth device named MOMENTUM. Set MOMENTUM_ADDRESS to pick one by address instead. Each command opens one Bluetooth session under a shared lock, so only one runs at a time.

momentum status --json prints every setting. One the firmware rejects is null.

Settings

momentum set --help lists them: anc, adaptive, transparency, anti-wind, bass-boost, sound-mode, eq, eq-band, eq-preset, codec, call-profile-switch, auto-answer, auto-power-off, comfort-call, on-head-detection, smart-pause and touch-controls.

Codec and call profile

These are PipeWire settings on the PC, not headset ones. Picking a codec switches the headset to its A2DP profile, which also leaves the call profile. The call profile switch is WirePlumber’s bluetooth.autoswitch-to-headset-profile, saved with wpctl, so it applies to every Bluetooth headset. With it off, music stays in high quality but calls use another mic.

Equaliser

The headset has five bands, labelled 63 Hz, 250 Hz, 1 kHz, 4 kHz and 8 kHz in Smart Control. Gains are in dB, in tenths. The presets are Smart Control’s eight, plus a Harman preset fitted from AutoEq’s Momentum 4 corrections. The curve is stored on the headset, so it carries over to other devices.

Last updated on